Use the JapharFlasher v1.1 just to flash the SSL88 ALLSIM. Reboot the box into Web Interface Flash mode.

Then use the WebInterface (with Browser like Chrome) to flash the full image from that list of our original images we published.

TS

Hi thanks I have flashed the SSL 88 ALLSIM with JapharFlasher says box flashed ox when I disconnect and press dreambox botton in and hold in power on comes up as dreambox 2nd failed I cant get into web interface as I cant get into the stop mode to show the box id any idea

Did you tried to flash then the original SSL88 with JapharFlasher ? Try it and let us know what happens then after reboot.

http://www.ourdreambox.com/ubbthreads.ph...sev2-88.nfi.rar

Attached a SSL89 NFI, try it as well and let us know if it works.

Admin

hi I have connected box with Japhar 1.1 connection ok flash the Allsim 88ssl box flash ok keep power on flash original open ATV genuine image from the link you gave me says box flash successful disconnect power of DM box power back up same result dreambox 2nd failure with a warning sign over a chip and a net cable showing on the LCD display in the Japhar should the net box be ticked or not I have tried it both ways same result also when using Japhar it is in serial mode when flashing is that correct I have left the power on after it said box flashed ok I tried leaving power on and web browser put in ip address and got dreambox firmware on ok it shows box as 87j ssl strange!!

Important point, once flash the SSL, you MUST REBOOT the box into Flash mode again. You cannot just flash the SSL and then immediately after the image as it would mean the first SSL is not "seen/loaded" by the box, and only the image is.

JapharFlasher and DreamUp have inside their own SSL, so it could happen that you have something with an older or different SSL when in rescue mode. But then it will write the NFI file you load.

Did you tired to then flash the original SSL88 and the SSL89 ? What are the results. Try the SSL88 (then reboot and tell us result) and then the SSL89 (then reboot and tell us result).

Did you had this problem also before you flashed the image that got you into NO CA ERROR ? Reason of flashing a new image ? As your chip could have failed and could need replacement (you could remove it and solder a simsocket and install a Japhar Sim, if the chip is dead).

First of all try the SSL88 and SSL89, and tell us for each one the results.

Admin

Hi everyone
Good morning
I have a question. In the display screen in dreambox 800hd se v2 i can see a message following the bootup "Dreambox 2nd failed" how to fix this error.
thank you
Have a wonderful day

Read here,

http://www.ourdreambox.com/ubbthreads.php?ubb=showflat&Number=15214#Post15214

Admin