You will need to flash the SSL89-v6, and if you want you can replace the Japhar drivers by the new Japhar v6 drivers.

Admin

Hello
ok Thank you
But do I have to replace the drivers or the V5 image will be compatible if I only flash the SSL89-v6 using a sim flashed to OS6 ?

Drivers v5 for DM800HDseV2 (only that model) are no more compatible with the Sim v6 Japhar OS. You need to replace them by the Drivers v6.

Admin

Hello
ok just before starting, the driver bcm7405.ko can be replaced before flashing or there is a risk. I know the v5 image wont work but after flashing canI still access the dreambox via ssh or I better replace before flashing ?
Thx

The driver doesn't block anything (You will just not have any image/video), the only important thing to replace is the old SSL v5 by the new SSL89-v6 otherwise you will get a NO CA ERROR (that can be recovered by JapharFlasher). This happens only for DM800HDseV2, all other boxes will boot ok but no image/audio if you have v3-v5 OS and boot image v6.

Admin

Great
... SSL already replaced
Thx for support

I patched through Jam
it worked said patched and rebooted the box
but it is kinda stuck here

Apr 15 15:56:18 dm800sev2 daemon.info init: Id "gui" respawning too fast: disabled for 5 minutes

It is a V5 image with the replaced ko module

Should I try a V6 image or it should still work with just replacing the ko module

Is there a way to check the OS version of the Sim card ?
just to be sure it really patched it

The only good way to test the sim, to be sure it's OS v6, is to flash the OpenVision v6 image and see if it works (You can also flash a v5 image and if you have NO CA ERROR then you know the sim is OS v6).

Patching is not always possible, depending of the image. If the image is available in v6 version, better is just to flash the v6 new image and then restore the settings on it.

All Sim sent since April 2019, are flashed with the v6 already.

Admin

Hi,
Tried to flash sim to OS v6. Now Bios no Ca found. Tried almost everything suggested bu without result.
DM800seV2. Recover with Japharflasher 1.1 gives flashing successfully, but still No CA found.

Hello !

That's the only box the DM800HDseV2 that had a big "change" in the software.

With JapharFlasher v1.1, flash a v6 image, and you will get your box working as good and better than before.

If you need to backup your configurations in the box, flash the SSL89J-v6 first (That will get your box compatible with the new Sim OS v6, then backup the files you need and finally Flash a v6 image, and restore files you need/settings/configurations).

Admin

JapharFlasher v1.1 : http://www.ourdreambox.com/ubbthreads.php?ubb=showflat&Number=9476#Post9476

DM800HDseV2 v6 images : http://www.ourdreambox.com/ubbthreads.php?ubb=postlist&Board=49&page=1

SSL89J-v6 : http://www.ourdreambox.com/ubbthreads.php?ubb=showflat&Number=18335#Post18335