It is perfectly working, see screenshot below on Chrome.

We do images only for the 30+ boxes we publish here.

For your box, some old images available here below,
http://downloadtmsw.com/bbs/reply.php?board=tmnano3tcombo&num=9

Admin

Respected Sir,

Screen shot of the openpli is shown for Dreambox DM900 in the above attachment. Whether this link can be applied for Dreambox DM920 UHD also.

Seen the link for Technomate Nano 3T Combo & its firmware updates is up to 18th Feb 2018. Please suggest can I replace any other latest software, which is compatible for technomate nano 3t combo.

Thanks

Go on the DM920UHD Section for the images, and select the one you want from there.

I only checked the links you published, and both worked. If it wasn't for your box, then go on the right section for your box and find the right link for your box.

Admin

Respected Sir,

Regarding Dream Box DM 920 UHD

My box is running with the below software & .bin

dreambox-image-deb-dm920-20200515.tar.xz
zImage-rescue-3.14-r0-dm920-20200511.bin

Now, there is a latest software & .bin available @ https://www.dreamboxupdate.com/opendreambox/2.5/unstable/images/dm920/index.php which is shown below:-

dreambox-image-deb-dm920-20200526.tar.xz
zImage-rescue-3.14-r0-dm920-20200525.bin

My concern is, in order to flash
"dreambox-image-deb-dm920-20200526.tar.xz" how to install "zImage-rescue-3.14-r0-dm920-20200525.bin"

Thanks

You don't have to flash the bootloader, that stays inside the box (it's a different partition), and the image doesn't need to be flashed again, you just have to do the online update that is available in the Parameters menu of the image/GUI. It will update the software differences between the 26 and 11 version, and you will have all good and upated.

Admin

Respected Sir,

I switched off & switched on & touched my finger on the blinking red light immediately. My dreambox dm 920 displays rescue mode waiting for DHCP instead of http://dm920.local.lan/

This happens always, after updating the latest software.

In the post #21380 - 05/21/20 03:24 PM 20200515.tar.xz software was successfully flashed, with http://dm920.local.lan/

Could you please suggest.

Pressing the frontpanel button you set your box to rescue mode, you should flash the new image and it will boot normaly.

Or the other option is to send the reverting commands, to set it as boot and no more rescue mode. Telnet/SSH to the rescue modem/partition and then send command below.



Admin

Respected sir,

1st Option is not working for me. Message on LCD Display "Rescue Mode - Waiting for DHCP". Is there any alternate for bringing the "Rescue Mode To http://dm920.local.lan/

2nd Option, i have not understood. Telnet/SSH to the rescue modem/partition. After sending the below code, whether I will get option for flashing latest firmware.

"echo "normal" >> /proc/stb/fp/boot_mode && reboot"

Thanks

Your box is set on "rescue" mode so you have to change this, sending the command while you are logged in terminal mode (telnet/ssh). For it use Telnet on your PC computer or Putty software.



Admin

Respected Sir,

After sending the below code via telnet

Code:

echo "normal" >> /proc/stb/fp/boot_mode && reboot

Message from telnet was
*** Server has closed***

Again, by pressing the red button for few seconds on the front panel shows "Rescue Mode waiting for DHCP"

Could you please guide me what is the next step