Hello.

I have a problem with my DM 900.
The problem is described as "DM900 red light" - only the power and LAN LEDs are lit in red.

No possibility to enter recovery, no LAN communication.

The only communication is via the service connector and reading via putty.

I tried resuscitation via OptiFlsher, but I can't do anything without activating the software, and the project is probably dead.
Do you have an idea for reviving the box?

JapharFlasher not comunication on COM3

Quote:
CPU 01
Dreambox DM900
AVS init...
AVS init OK
AVS load:select_image: addr_offset: 00051000 part_offset: 00000000 bootStatus: 2a002b00
AVS load_code offset =00051000
LOADED
AVS: overtemp mon ON

single board
select_image: addr_offset: 00055000 part_offset: 00000000 bootStatus: 3d2b2500
MEMSYS-STD
SHMOO 02010000 BLD:11138M HW:hpf0_b1p6 V:2.1.0.0
MCB: FLEX
AVS start:status=000000ff
STB: Current voltage=00000386(902)
temperature=0000c015(49173)
PV=00000349(841)
MV=00000387(903)
AVS FW rev=30333278 [0.3.2.x]
OK
DDR0: !@ ffe0e780 <= ffe0df10 MEMSYS-0 @ f1100000 OK
DDR1: =@ ffe0e780 <= ffe0df10 MEMSYS-1 @ f1180000
MEMSYS ERROR: 00000001

eMEMC:
00000000
ePHY: 00000000
eSHMOO: 10000000 00000082 00000000
CPU 01
Dreambox DM900
AVS init...
AVS init OK
AVS load:select_image: addr_offset: 00051000 part_offset: 00000000 bootStatus: 2a2f2b00
AVS load_code offset =00051000
LOADED
AVS: overtemp mon ON

single board
MEMSYS:0000002f
FATAL ERROR: Boot 2nd image failed