Hi,
my dm800se is starting to have weired behaviour when I boot it.
At switch on, very often, I got "NO CA FOUND" but the flash image is ok.
I have to try to switch it on and off several time before it starts to boot regularly. Also, even if I set up the bios correctly for the USB boot procedure it wont boot anything from usb. I'm sure that usb pen and the bios settings are ok because I have another Dm800se and with same settings it boots ok from usb pen. The usb ports seems to work correctly.
I think I might have bios / flash chip issue or something on related HW.
Any suggestion on what to do and what to check to solve this issue ?
Many thanks for your patience and time.
Best regards

The sim seems to be defective, if you have such error "NO CA FOUND", it means it doesn't find the sim card.

It would be good to replace it (by a Japhar).

Admin

Ok, I will swap the sim between the my two decoder and check is. the issue goes with it.

Another strange behaviour is that with the usb pen inserted it does not respond to the front switch pressed when I switch it on, meaning that it does not go into the firmware upload mode, but it boots as a standard. to put it in to upload FW mode I have to remove the usb pen.

Do you still think it might be a sim problem ?

One additional info:
to haveit boot from a usb pen I have to keep the front botton pushed during the first part of the booting as I want to fhash a new image. If I do not do that it boots from the flash image even if the bios is set to boot from usb pen

Try to reset the BIOS and reinsert your parameter,

http://www.ourdreambox.com/ubbthreads.php?ubb=showflat&Number=5234#Post5234

TS