Scuse me D2mac and Admin , i have install with d2mac method and the A867 run very well. thank you so much.
although it gave me error it install the same, and is necessary set 5v in decoder dvbt setting

You need to use OpenPLI 4.0 from MastaG ONLY ! As well as you need to properly do as described... if you have such error, it means you done or missed something, as if the file is not present it means you didn't copied it where you use it... etc... be sure you do things properly.

This is the reason why we setup 2 easy ways,

- Commands to send (4 commands)
- GUI install via the JAM 5.2 as explained

These 2 are working and are simple,

Good that finally you were successful, as explained it works and it's only a matter to do properly the installation as explained. Well done.

Admin

On original DM800SE with openpli 4.0 o.e.2.0, i have install 9035 driver from panell , and after i have install right driver with this command from telnet " opkg install kernel-module-dvb-usb-a867 " and reboot

can someone please build this
v4l-dvb-module-dvb-a867_2.6.18-7.4-dm800+20100904-r0_dm800.ipk

with gcc_4.6 for dm800
can you please point to the source too

Thanks/Grazie

See here,

http://www.ourdreambox.com/ubbthreads.php?ubb=showflat&Number=326#Post326

TS

On openpli 4.0 for original dm 800 se , i installed

v4l-dvb-module-dvb-usb_2.6.18-7.4-dm800se+20100904-r0_dm800se.ipk
v4l-dvb-module-dvb-a867_2.6.18-7.4-dm800se+20100904-r0_dm800se.ipk

but at reboot the yellow bar progress , stop at hal and i must do reflash the box.
What are the right driver for original box?

This should work and be enough in all cases and for all boxes,

Admin

For DM :


For VU+ :

un saluto Grandioso a Tutti Voi

funziona al 100x100

1000 Grazie ancora.

;o), Enjoy !

Admin